USER GUIDES
START USING YOUR GLORICON GOPRO BLEND
1. Charge your Gloricon GoPro Blend for 3 hours or until the light ring glows white.
NOTE: BLENDER WILL NOT OPERATE WHILE CHARGING.
2. Prior to the first usage, clean your Gloricon GoPro Blend by adding water, a drop of soap, blending, and rinsing.
3. Make sure Jar is tightly attached to base before blending or it will not blend.
4. Add liquids first, then your choice of solids. Make sure the ingredient volume does not exceed 2/3 of the jar.
5. Press the power button twice to make the drink of your choice.
6. Press and hold the power button twice, tilt the blender at a 45-degree angle while holding the power button (Power Mode), and then bring it back upright if it becomes stuck.
6. Make sure to clean immediately after every blend to avoid bacteria growth.
CRUSH ICE EFFORTLESSLY...
1. Add ice cubes not too large to prevent blender from getting stuck while blending.
2. From an up right position, tilt the blender 45 °, start blending by pressing and holding the button twice. (power mode) Then proceed to turn the blender back to an up right position.
3. Give the blender a slight shake if the ice cubes become stuck to make sure everything is thoroughly blended.
Faulty Indicators
Red light flashes 5 times ?
The Jar is not attached to the base correctly.
SOLUTION: Try re-attaching jar to base. Make sure it is tightly attached.
Red light flashed 10 times ?
Low or out of battery.
SOLUTION: To achieve a better blend, we recommend charging for 3 to 5 hours.
Blender stops while operating ?
The blender will stop if there is not enough food in the Jar.
SOLUTION: Add or reduce food from jar and re-start the blending process.
Red and White light flashes 10 times while operating ?
The motor has locked due to a blockage.
SOLUTION: Ensure there isn't any food blockage in between blades.
Leaking ?
The silicon in lid and base is not attached properly.
SOLUTION: Check if silicon in lid and base are properly attached before blending.